CORRECT USAGE
When you use the air conditioner at the first time or when you change the setup value, follow the procedure below. From the next time, the operation displayed on the remote controller will start only by pushing ON / OFF button.
Preparation
• The operation lamp (Red) flashes.
REQUIREMENT
•While using the air conditioner, operate it only with ON/OFF button without turning off the power switch.
•When starting the operation after stop for a long time, turn on the power switch for 12 hours or more before start. (This is required because it is necessary to turn on the compressor case heater for heating in order to prevent overload on the compressor when activating the outdoor unit.)
1
2
For every push of the button, the display changes as right figure :
The display changes as follows :
FAN | COOL | HEAT |
LOW | MED. | HIGH | AUTO |
•When air volume is “AUTO”, air volume changes according to the room temperature.
The operation lamp goes on, and the operation starts .
MODE FA N T EMP.
F A N CHECK | ADDRESS UNIT STANDBY | |
C O O L 1 2 |
| FILTER |
|
| PREHEAT |
H E AT AU TO |
| DEFROST |
CENTRAL | LOUVER | |
F I X | MANUAL | |
MODE |
|
|
FILTER CHECK | 2 | 3 |
1 |
STOP | ON/OFF | |
Push “ON/OFF” button. | 4 | |
The operation lamp goes off, and the operation stops. | ||
|
NOTE
• When the operation button is pushed, the operation starts approx. 1minute after.
•When pushing “ON/OFF” button, the indoor fan starts
•When the room temperature reaches the set up temperature and the outdoor unit stops, the mode becomes LOW and air volume decreases accordingly. During defrost operation, the fan stops so that cool air is not out, and “PREHEAT” and “DEFROST” are displayed.
•In heating operation, the fan operation may continue for approx. 30 second.
•When restarting the operation immediately after stop, the air conditioner does not operate for approx. 3 minutes to protect the machine.
84