Operation section
Push each button to select a desired operation.
1
2
3
4
5
Selects desired operation mode.
Selects the desired air volume mode
Adjusts the required room temperature.
Match to the desired set temperature by
pushing .
Resets (Erases) “FILTER” display.
When an error/fault occurs on the air conditioner, this button is used to check the check code indicating fault status.
Lamp is lit during the operation.
Lamp is off when stopped.
Although it flashes when power switch is turned on or when turned on again after power failure, it goes on if the operation has started.
With auto louver function, the discharge louver operates or stops during operation of air condi- tioner.
When the button is pushed, the operation starts, and it stops by pushing the button again.
When the operation has stopped, the operation lamp and louver display disappear though other displays remain as they are.
When using a remote controller connected to a central remote controller, etc., contents which can be operated by the standard remote controller and “CENTRAL” display change by setting at the central remote controller.
Setup on central remote controller
(No display)
“CENTRAL” display on
standard remote controller
Goes off
Contents operated by standard remote controller
Operated from both standard remote controller and central remote controller, and operated with contents specified later.
Center
Goes on
ON / OFF only can be operated.
Operation inhibit
Flashes
Cannot be operated.
For application control using other “Weekly timer” or “Central remote controller” other than this standard remote controller, refer to the Manual attached to each remote controller.
83