Toshiba RAM-SM560AT-E Installation/Servicing Tools, Remote Controller Cabling, Cabling diagram

Remote Controller Cabling

•Strip approx. 14mm the cable to be connected.

•Non polarity, 2 core cable is used for cabling of the remote controller.

•Twist cable of the remote controller to be connected with cable of the remote controller unit (or sensor), and press-fit them with a wire joint.

(Wire joints (White: 2 pieces) are included in the attachments to the remote controller (sold separately) or the wireless remote controller kit (sold separately).

			Approx. 200mm			W : White
Terminal block		A				B : Black
				W
						Remote controller
for remote controller		B		B		unit or sensor part
cabling of indoor unit
	Remote controller cable		Connecting		Remote controller unit or
	(Procured locally)		part		cable from sensor part

Cabling diagram

Remote controller cabling

Cable from remote	Wire joint
controller unit

Remote controller

Remote controller

cable

A B

Indoor side

1 2 3

Indoor/Outdoor connecting cable

1 2 3

Outdoor side

L N

(Single phase 220/230/240V)

•For details of cabling/installation of the remote controller, refer to the Installation Manual attached to the remote controller.

Check and Test Operation

Be sure to test the pipe connections for gas leak.

•Check the flare nut connections, valve stem cap connections and service port cap connections for gas leak with a leak detector or some soap water.

9 INSTALLATION/SERVICING TOOLS

Tools

Tools	Applicable to R22 model
Gauge manifold	o
Charge hose	o
Electronic balance for	¡
refrigerant charging
Torque wrench
(nominal diam.	o
1/4, 3/8, 1/2, 5/8)

Tools	Applicable to R22 model
Flare tool (clutch type)	¡
Gauge for projection	__	____
adjustment
Vacuum pump adapter	¡

Gas leak detector o

¡: Newly prepared (They are special requirements for R407C, separate from those for R22.)

o: Existing tools are available.

For the details of the tools, refer to the Installation manual of the outdoor unit.

78