Authentication: network situation, and the password should not be more than 15 characters.

All Interfaces: Here you can operate all the interfaces in bulk. All the interfaces will not apply RIP if “Enable” option for All Interfaces is selected.

¾List of RIP

After RIP is enabled, the information of RIP forwarding the packets received by the Router will be displayed in the list.

The first entry in Figure 3-43indicates: when receiving packets with destination IP is 116.10.20.28, the Router will select WAN1 which is in the same network with the destination IP as next hop and forward data via this port. The IP address of next hop is 116.10.1.254 and the hop count is 1. The effective time of this entry is 1 second.

Note:

RIP function cannot be set if the Router is in NAT Mode. To set RIP function, please change the System Mode to Routing or Full Mode.

The RIP function of WAN port takes effects only when the Connection Type of this WAN port is Static IP.

3.3.5.3Route Table

This page displays the information of the system route table.

Choose the menu Advanced→Routing→Route Table to load the following page.

Figure 3-44 RIP

Destination: The Destination of route entry.

Gateway: The Gateway of route entry.

-69-

Page 74
Image 74
TP-Link TL-ER5120 manual Route Table, ¾ List of RIP