6.1.5 PPPoE

PPPoE: Stands for Point to Point Protocol over Ethernet

A standard builds on Ethernet and Point-to-Point network protocol. It allows your camera with xDSL or cable connects with broadband network directly, then your camera can dial up and get a dynamic IP address. For more PPPoE and Internet configuration, please consult your dealer or ISP.

The camera can directly connect to the xDSL, however, it should be set up on a LAN environment to program the PPPoE information first, and then connect to the xDSL modem. Power on again, then the camera will dial on to the ISP connect to the WAN through the xDSL modem.

The procedures are

Connect to a LAN by DHCP or Fixed IP

Access the camera, and enter Setting Î Network Î PPPoE as below

¾PPPoE: To enable or disable the PPPoE service here.

¾User name: Type the user name for the PPPoE service which is provided by the ISP.

¾Password: Type the password for the PPPoE service which is provided by the ISP.

¾IP address, Subnet mask, and Gateway (read only): Shows the IP information got from PPPoE server site.

¾Status: Shows the Status of PPPoE connection.

29

Page 37
Image 37
TP-Link TL-SC323ON, TL-SC3230N manual PPPoE