30 THE MICROWAVE SYSTEM
4.Using acetone, clean the oven floor where the new wave guide cover will sit.
5.Apply a 1/8” diameter bead of high temperature RTV (included with Item 29) along the outside edge of the wave guide cover flanges.
N O T E : It is important to use the correct high temperature RTV as supplied by TurboChef.
6.Place the new wave guide cover in place. Secure with the fourteen (14) screws provided with Item 29.
7.Wait 15 minutes for RTV to cure.
8.Warm oven to set temperature and
W A R N I N G : Inside of oven and IR element are HOT! Use extreme caution during step 8.
WAVE GUIDE/WAVE GUIDE COVER PARTS
Figure 22
29.NGC-3036 Kit, Wave Guide Cover (Includes Item 31 and sealant)
30.101666 Screws,
31.101701 Screws, #8, SST
32.NGC-1047 Support, Frame
33.102809 Screws,
34.
35.
36.
37.
WAVE GUIDE REPLACEMENT
1. Remove the wave guide cover. See WAVE GUIDE
COVER REPLACEMENT on page 29.
2.Remove the right side panel and frame support (Item 32).
3.If replacing the front wave guide, use the NGC- 3016 kit. If replacing the rear wave guide, use the
4.Remove the two (2) right and
5.The wave guide should now be loose enough to easily slide out from the right side of the oven.
N O T E : Be careful to not damage the insulation when removing the wave guide.
6.Install the new wave guide using the mounting screws provided with the kit (Item 34 if rear wave guide, Item 37 if front).
C A U T I O N : Do not pinch insulation between the wave guide and oven bottom.
7.Reinstall the wave guide cover.
8.Reinstall the side panel and apply power to the oven.
HIGH VOLTAGE AND FILAMENT TRANSFORMER
REPLACEMENT
Wiring the High-Voltage Transformers
The proper reinstallation of the
As shown in the schematics, transformers are installed mirror opposite and wired 180º
With the Microwave System energized, the volt meter will read the incoming voltage (different readings for
different countries). If the meter reads 0 VAC, the