Ultimate Technology 500 POS manual LED Turns on

Table 3. Local Mode Programming Instructions - Continued

Note: *Default Settings

Function Code(s)	Operation	Normal Indication	Remarks
	Note:	Disabling all format tracks will not disable the secure or
	programming operations.

09	1. While in programming mode, at the Series 500 Keyboard numeric
Magnetic Stripe	keypad, enter Function code 09.
Reader (MSR)
Beeper	LED (2)	turns on.
	2. At Series 500 Keyboard numeric keypad, enter the applicable
	number (1 through 4) to select magnetic stripe reader beeper
	operation per list below.
	1	= beep on good read for all enabled tracks
	2	= beep on bad read for all enabled tracks
	3	= beep on good or bad read of enabled tracks*
	4	= no beep on good or bad reads
	LED (2)	turns off.
	3. Program the next function code or exit the local programming mode
	by entering 99 on Series 500 Keyboard numeric keypad followed by
	ENTER or by swiping the Programmer's card. If using the optional
	3- position keyswitch, move switch out of the AUX position.
10	1. While in programming mode, at the Series 500 Keyboard numeric
11	keypad, enter applicable Function Code 10, 11, 12 or 13.
12
13	LED (2)	flashes.
Magnetic Stripe
Reader (MSR)	2. At the auxiliary keyboard, press the desired key or type the desired
Channel 1,3	key sequence. Note that the maximum number of key codes that
Prefix (10)	can be entered is limited to 24 - this is the equivalent to
Field	approximately 12 key strokes.
Separator (11)		If the Series 500 Keyboard
		beeps and LED (2) turns off
Suffix (12)		while entering key codes at
		the auxiliary keyboard, you
Account		have exceeded 24 key codes.
Separator (13)		Repeat steps 1 and 2.
	3. At the Series 500 Keyboard, press ENTER.
	LED (2)	turns off.
	4. Program the next function code or exit programming mode by
	entering 99 on Series 500 Keyboard numeric keypad or by swiping
		21