Ultimate Technology 500 POS manual Move switch out of the AUX position

Table 3. Local Mode Programming Instructions - Continued

Note: *Default Settings

Function Code(s) Operation Normal Indication Remarks

	the Programmer's card. If using the optional 3- position keyswitch,
	move switch out of the AUX position.
14	1. While in programming mode, at the Series			500	Keyboard			numeric
15	keypad, enter applicable Function Code 14, 15, or 16.
16
Magnetic Stripe		LED (2) flashes.
Reader (MSR)
Channel 2	2. At the auxiliary keyboard, press the desired key or type the desired key
Prefix (14)	sequence.	Note that the maximum number of key codes is limited to 24
	- this is equivalent to approximately 12 key strokes.
Field
Separator (15)		If	the	Series		500		Keyboard
		beeps and LED (2) turns off
Suffix (16)		while entering key codes at the
		auxiliary		keyboard,			you		have
		exceeded 24 key codes. Repeat
		steps 1 and 2.
	3. At the Series 500 Keyboard, press ENTER.
		LED (2) turns off.
	4. Program the next function code or exit programming mode by entering 99
	on Series 500 Keyboard numeric keypad or by swiping the Programmer's
	card. If using the optional 3-position keyswitch, move switch out of the
	AUX position.
17	1. While in programming mode, at the Series			500	Keyboard			numeric
18	keypad, enter applicable Function Code 17 or 18.
Magnetic Stripe
Reader (MSR)		LED (2) flashes.
Channel 1,3
Bad Read (17)	2. At the auxiliary keyboard, press the desired key or type the desired key
	sequence.	Note that the max imum number of key codes is limited to 24
Channel 2	- this is equivalent to approximately 12 key strokes.
Bad Read
Macro (18)		If	the	Series		500		Keyboard
		beeps and LED (2) turns off
		while entering key codes at the
		auxiliary		keyboard,			you		have
		exceeded 24 key codes. Repeat
		steps 1 and 2.

3.At the Series 500 Keyboard, press ENTER.

LED (2) turns off.

22