Ultimate Technology 500 POS manual Series Keyboard Description Numeric Keypad no, Break

Table 4. Local Programming Commands For Key MAKE/BREAK And Extended Functions

SERIES 500
KEYBOARD	DESCRIPTION
NUMERIC
KEYPAD NO.
0	Aborts changes to macros.
1	Defines where the output of MAKE codes end and BREAK codes start. Prior
	to this command, all codes are sent when the keys are pressed (MAKE
	codes). After command, all codes are sent when keys are released (BREAK
	codes).
2	Defines where repeating function of keys start. After command, all keys
	repeat code when keys are held down past repeat time.
3	This command overrides PC settings for key. Key sends code as typed on
	BREAK.
4	This command overrides PC setting for repeat. Key sends code as typed on
	MAKE and BREAK.
5	This command removes all BREAK codes from the macros except for SHIFT,
	CONTROL and ALTERNATE keys.
6	NOTE: Only available in 00 and 01 commands.
	Defines the position of a key on the Series 500 Keyboard. Note that a Sec Op
	Key must be defined on the Series 500 Keyboard to enable programming of
	secondary-level key codes.
7	NOTE: Only available in 00 and 01 commands.
	Defines the position of a Sec Op Lock Key on the Series 500 Keyboard.
9	Used to erase the macro from the primary and/or secondary key position.

EXAMPLE 1.

This example programs where the Series 500 Keyboard MAKE codes end and BREAK codes start using the "A" key.

1.Place the Series 500 Keyboard in local programming mode.

2.At the Series 500 Keyboard numeric keypad, enter 00 or 01.

33