Table 5. Remote Programming Mode Commands - Continued
OP | MNEMONIC/DESCRIPTION | COMMAND/ACKNOWLEDGEMENT | |
CODE |
|
|
|
(HEX) |
|
|
|
|
|
| |
B4 | COMMIT | COMMAND: B4<CR> | |
| Writes programming changes to | B4 | = Op Code |
| the NVRAM. Always apply the | <CR> | = terminate command (0D hex) |
| COMMIT command after |
|
|
| programming the keyboard to save | ACKNOWLEDGEMENT: NONE | |
| the changes in the NVRAM. Failure |
|
|
| to use the COMMIT command will |
|
|
| result in the loss of the changes the |
|
|
| first time power is removed from |
|
|
| the keyboard. |
|
|
|
|
| |
B5 | RESET | COMMAND: B5RST<CR> | |
| Resets keyboard after downloading | B5 | = Op Code |
| configuration. On receipt of this | <CR> | = terminate command (0D hex) |
| command the unit does a warm |
|
|
| boot. | ACKNOWLEDGEMENT: NONE | |
|
|
| |
B6 | KSSND | COMMAND: B6<CR> | |
| Used to select when keyswitch 1, 2 | B6 | = Op Code |
| or 3 MAKE/BREAK codes are | x | A = unsolicited |
| sent. Two options are available: |
| B = solicited |
| unsolicited mode where codes are | <CR> | = terminate command (0D hex) |
| sent whenever the keyswitch is |
|
|
| rotated, or solicited mode where | ACKNOWLEDGEMENT: NONE | |
| codes are sent only when a OP |
|
|
| Code B7 command is received. |
|
|
|
|
| |
B7 | KSSTATUS | COMMAND: B7<CR> | |
| Send keyswitch MAKE/BREAK | B7 | = Op Code |
| codes in current keyswitch 1, 2 or 3 | <CR> | = terminate command (0D hex) |
| position. | ACKNOWLEDGEMENT: NONE | |
|
| ||
|
|
|
|
|
|
|
|
47
