20

Verizon One User Guide

7. Installing the Verizon One Base Unit

7.3Wall Mounting on a Hollow Drywall Surface (Optional) (cont’d)

6.Connect the DC 12V power supply cord to the power connector marked 12V DC on the rear panel of the Verizon One Base Unit. Plug the other end of the power supply into an AC wall socket, and then turn on the power switch (if it is not already on).

7.Check the Base to see if the Power LED is solid green. If the Power LED is solid green, the Verizon One Base is powered up.

8.Verify telephone operation by pressing the <Speakerphone> button found on the front of the Base Unit. Once pressed, the In-Use LED should be solid blue and a dial tone should be heard from the speaker.

9.Once telephone operation has been verified, snap the Base Unit

Swivel stand onto the base. Adjust the stand by pressing the paddle and tilting the base until the top of the Base Unit touches the edge of the circular stand. The Base Unit must be installed in this position. Prior to placing the Base Unit and Swivel Stand onto the wall, use the cable management grooves within the bottom of the stand to guide the Power and telephone cables, so that the stand can sit flush with the wall. Mount the unit to the wall.

10.Once the unit has been mounted to the wall, re-verify telephone operation by pressing the <Speakerphone> button on the front of the Base unit. Once pressed, the In-Use LED should be solid blue and a dial tone should be heard from the speaker.

© 2006 Verizon

Page 20
Image 20
Verizon Verizon One manual Wall Mounting on a Hollow Drywall Surface Optional cont’d