118

Verizon One User Guide

20. Home Networking

20.3.4 Installing a Wired Network

Preparation

1.Before you connect your “Wired” network, you must have an Ethernet card installed in each computer that you plan on adding to your network. If your Ethernet card does not auto- negotiate, you must set it to half duplex. Refer to the Ethernet card manufacturer’s instructions for installing and configuring your Ethernet card.

Note: Ethernet Cards can be purchased at www.verizon.net/niccard.

Add Computers to your Wired Network

2.Connect an Ethernet cable from the Ethernet (E2, E3, or E4) jacks marked on the rear panel of the Verizon One base station to the

Ethernet port on the computer you are adding. Repeat this step to connect up to two additional PCs to Verizon One.

NOTE: You may connect to any of the three Ethernet (E2, E3, or E4) jacks on the rear panel of the Verizon One base station as they serve as an Ethernet switch. Your Verizon One installation kit contained one

(1)Ethernet cable (yellow) for your primary connection. Additional Ethernet cables are not provided and must be purchased separately. The WAN/E1 jack is used for WAN transport when installing Verizon One without DSL.

© 2006 Verizon

Page 118
Image 118
Verizon Verizon One manual Installing a Wired Network, Preparation, Add Computers to your Wired Network