19

Verizon One User Guide

7. Installing the Verizon One Base Unit

7.2Installing the Base Unit on a Desktop or Flat Surface (cont’d)

Step 3

Follow the Instructions on the Verizon One Display (Figure 3).

The Verizon One display will walk you through the necessary steps to complete the set-up of Verizon One and the installation of your Verizon Online DSL Service (if required).

Figure 3

7.3Wall Mounting on a Hollow Drywall Surface (Optional)

Follow the steps below to mount Verizon One on a wall:

NOTE: The hardware needed to wall mount Verizon One is not included with the product.

1.Obtain two #8 pan-head screws and two #8 wall anchors.

2.Place the Verizon One Base Unit stand against the wall where it is to be mounted. Using a pencil, mark one of the two corresponding screw locations. Mark the other at the appropriate distance vertically.

3.Drill a 3/16” hole for the wall anchors and insert. Screw in the #8 screws until the face of the screws are approximately 1/8” from the wall.

4.Test-fit the Verizon One Base Unit swivel stand on the screws and adjust the screw depth for a sliding fit. Once the stand fits tightly against the wall, remove it from the wall.

5.Connect the phone cable (included) from the jack marked DSL on the rear panel of the Base Unit to the telephone wall jack provisioned for DSL and phone service. This connection will provide dial tone for voice services in addition to providing DSL to your Verizon One.

(Note: Verizon One has a Fax Jack that can be used to connect additional telephone equipment such as a fax machine).

© 2006 Verizon

Page 19
Image 19
Verizon Verizon One manual Installing the Base Unit on a Desktop or Flat Surface cont’d