Vidikron Vision 75, Vision 65 Base Plate Prismatic Lens, Do not OVER-TIGHTEN the Screws

	Installation
To install the fixed CineWide base plate on a Vision 65/CineWide or Vision 75/CineWide with	Installing the Fixed CineWide
a prismatic anamorphic lens:	Base Plate (Prismatic Lens)

1.Place the projector upside down on a blanket or other soft surface.

2.Line up the two mounting holes on the CineWide base plate with those on the bottom of the projector.

3.If you are mounting the projector on a ceiling: Line up the four holes on the projector ceiling mounting plate (included with the projector ceiling mount kit) with those on the bottom of the projector.

4.Secure the CineWide base plate (and ceiling mounting plate, if needed) to the projector with the four, M6x12mm screws and washers provided with the CineWide lens base plate. See Figure 3-8.

1. Do not use the mounting screws provided with the ceiling mounting Caution plate. Use only the hardware provided with the CineWide lens base

plate.

2.DO NOT OVER-TIGHTEN THE SCREWS.

Vision 65/CineWide or Vision 75/CineWide		Vision 65/CineWide or Vision 75/CineWide
	with Lens Base Plate	with Lens Base Plate and Ceiling Mounting
			Plate

Washers under Ceiling Mount Plate (2 places)

Figure 3-8. Vision 65/CineWide or Vision 65/CineWide with Whitney (Prismatic) Lens

Base Plate and Ceiling Mounting Plate - Bottom View

Vidikron Vision Model 65/Model 75 Installation/Operation Manual 23