Operation
Picture Memory: For each input, the Vision 65/75 lets you store picture quality settings as presets that you can recall at a later time. You can create up to four presets per input and resolution, to accommodate changing lighting conditions or viewer preferences.
To select a picture memory preset, highlight Picture Memory in the Picture Adjust menu. Then, press 
or 
to select “Custom 1,” “Custom 2,” “ISF Night” or “ISF Day.” When you select “Custom 1” or “Custom 2,” any changes to picture quality settings are stored in the selected preset.
1. To store changes to the ISF Night or ISF Day Picture Memory preset,
Note select that Picture Memory in the ISF menu (refer to ISF on page 59).
You must enter a passcode to access the ISF menu.
2.The Picture Memory selection you make here is not retained when the projector is powered off, then on again. To specify which Picture Memory should take effect when the projector is powered on, select it in the ISF menu.
Copy Settings: When you select the “Custom 1” or “Custom 2” Picture Memory preset, you can copy the settings from another preset to the selected preset. This gives you a convenient starting point for creating a new, custom preset. To do this, select Copy Settings from the Picture Adjust menu and press 
. Then, choose “Custom 1,” “Custom 2,” “ISF Night” or “ISF Day.”
To copy changes to the ISF Night or ISF Day Picture Memory preset, select
Note that Picture Memory in the ISF menu (refer to ISF on page 59). You must enter a passcode to access the ISF menu.
Brightness: On your external test pattern source, select a PLUGE pattern. (PLUGE is an acronym for “Picture
Below Black 
Above Black
Figure 4-2. Typical PLUGE Pattern for Adjusting Brightness
PLUGE patterns vary but generally consist of some combination of black, white and gray areas against a black background. The example above includes two vertical bars and four shaded boxes.
Vidikron Vision Model 65/Model 75 Installation/Operation Manual | 47 |
