Vidikron Vision 65 Troubleshooting Tips, Troubleshooting Chart, Symptom Possible Causes Solution

Maintenance and Troubleshooting

5.2

Troubleshooting Tips

Table 5-1provides some general guidelines for troubleshooting problems you may encounter with the Vision 65/75. If the suggested solutions fail to resolve the problem or if you encounter an issue not described here, please contact Vidikron Technical Support.

Table 5-1. Troubleshooting Chart

Symptom		Possible Cause(s)		Solution
The projector does not turn on.	•	The Vision 65/75 is not	• Ensure that the Vision
		plugged in or the AC outlet		65/75 is plugged in and
		is not active.		that the AC outlet is active.
	• The main power switch (at		• Turn on the power switch.
		the rear of the projector) is
		off.
	• Lamp cover is not securely		• Securely attach the lamp
		attached.		cover.
The projector does not turn	•	The projector will not turn	• Wait until the Vision 65/75
back on after it was powered		on for two minutes after		completes its cool-down
off.		power-off, to protect the		(POWER LED lights solid
		lamp.		orange).
The remote control does not	•	The batteries have run out.	•	Replace the batteries.
work correctly.
The projector is on and OSD	•	Incorrect source selection.	• Select the correct source.
menus appear, but there is no	•	Source component is not	• Turn on the source.
video image on-screen.		turned on.
	•	Source component is	•	Check cable connection
		connected incorrectly or		from source component to
		not at all.		projector.
A projected image from a DVD	•	DVD player is connected to	• Turn off progressive scan
is split or otherwise scrambled.		the Component input and		on the DVD player.
		set to progressive scan
		mode.
Image is blurred.	•	The lens is not correctly	• Adjust the focus with the
		focused.		remote control.
Image is too bright and/or	•	Contrast is set too high.	• Lower the contrast setting.
lacks definition in the bright
areas of the image.
Image appears “washed out”	•	Brightness is set too high.	•	Lower the brightness
and/or dark areas appear too				setting.
bright.
Colors in the image are	•	The Red/Pr, Green/Y or	• Ensure that the source
swapped; for example, reds		Blue/Pb outputs from the		outputs are connected to
appear blue or vice versa.		source are connected to the		the correct Vision 65/75
		wrong inputs on the Vision		input.
		65/75.
POWER LED lights solid red.	•	Internal failure.	•	Please contact your
				Vidikron dealer for
				assistance.

64 Vidikron Vision Model 65/Model 75 Installation/Operation Manual