Vidikron Vision 75, Vision 65 operation manual Adjusting the Horizontal X Lens Position

Installation

Configure Lens Motor Trigger: CineWide with AutoScope maintains constant image height independent of the aspect ratio, while using the full display resolution of the projector. It accomplishes this by moving the anamorphic lens in front of the primary lens when widescreen material is being viewed. When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens moves out of the light path.

To configure the lens motor trigger on the Vision 65/75 for proper AutoScope operation:

1.Press MENU on the remote control.

2.Select Setup from the Main menu and press ENTER.

3.Use the number buttons on the remote to enter the Setup menu passcode when prompted and press ENTER again. Then, press MENU on the remote control.

4.Select 12-volt Trigger from the Setup menu.

5.Set the 12-volt Trigger to “Cinema.” This enables the lens motor to move the anamorphic lens into position (in front of the primary lens) when the Cinema or IntelliWide 2.35 aspect ratio is selected.

6.Select the Cinema or IntelliWide 2.35 aspect ratio to move the anamorphic lens into position, if it isn’t already. To do this, press CINEMA or IWIDE 2.35 on the Vision 65/75 remote control (Figure 2-4).

Adjusting the Horizontal (X) Lens Position:

1.Project a white field on the screen.

2.Loosen the Yaw/X-Adjustment Levers underneath the lens.

3.Slowly move the anamorphic lens into place so that there are no shadows on either side of the screen:

Too Far Left

Correct position

Too Far Right

4.When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to secure the lens in place.

Vidikron Vision Model 65/Model 75 Installation/Operation Manual 37