VocoPro DTX-9909K Getting Started, About the Remote Control, Connecting the Power Cable

Getting Started

About the Remote Control

•The area between the remote control and the main unit must be clear of large obstacles.

•Do not expose the remote control sensor to strong light- ing, especially an inverter type fluorescent lamp as this may cause the remote control to not function properly.

Installing Batteries in the Remote Control

1.Turn the remote control over and slide the battery com- partment cover off towards the direction of the arrow.

2.Insert the AA batteries, positioning them according to the polarity (+, --) markings on the inside of the battery compartment.

3.Close the battery compartment cover.

Connecting the Power Cable

Plug the supplied AC power cable into the AC inlet after all other connections are complete and then plug the AC power cable to an AC wall outlet.

CAUTION

Use the supplied AC cable. Do not use other AC power cables as doing so may result in fi re hazard or electrical shock.

15V/60

Battery Replacement

If you fi nd that the distance between the remote control and the main unit must be shorter in order to use the remote control , this means that the batteries are low and must be changed. Replace both batteries with new ones.

Battery N otes:

•Use AA batteries.

•Be sure the polarities (+, --) are correct. (See the illustra- tion inside the battery compartment).

•Remove the batteries when not using the remote control for an extended period of time.

•If batteries leak, dispose of them immediately. Avoid skin, clothing and any other contact with the leaked material. Clean the battery compartment thoroughly before installing new batteries.

•Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon-zinc) with recharge- able (nickel-cadmium) batteries.

11