Charge light is off, There is no dial tone | VTech LS6245 specification

Appendix

Troubleshooting

The battery does not charge in the handset or the handset battery does not accept charge.

•Make sure the handset is placed in the telephone base correctly. The charge light on the handset should be on.

•Remove and reinstall the battery, then charge for up to 16 hours.

•If the handset is in the telephone base but the charge light on the handset is not on, refer to The charge light is off in this section.

•If the battery is completely depleted, it can take up to 10 minutes to charge the handset before HANDSET X appears on the screen (page 5).

•Purchase a new battery. Refer to the Battery section (page 77).

The CHARGE light is off.

•Clean the charging contacts on the handset and telephone base each month with a pencil eraser or a dry non-abrasive fabric.

•Make sure the power adapter and telephone line cord are plugged in correctly and securely.

•Unplug the power adapter. Wait for 15 seconds before plugging it back in. Allow up to one minute for the handset and telephone base to reset.

There is no dial tone.

•First, try all the above suggestions.

•Move the handset closer to the telephone base. It may be out of range.

•The telephone line cord might be malfunctioning. Install a new telephone line cord.

•Disconnect the telephone base from the telephone wall jack and connect a different telephone. If there is no dial tone on this telephone either, the problem is in your wiring or telephone service. Contact your telephone service provider.

83

Image 87

VTech LS6245 user manual Charge light is off, There is no dial tone

Contents

User’s manual Congratulations Table of contents Answering system operation..67 AppendixIndex Getting started Parts checklist Avoid placing the telephone base too close to InstallationCleaning tips for your touch screen telephone Important notes Telephone base installation Charge light Battery installation Battery charging VOL+ Handset layout Home Telephone base layout FLASH/X To enter the main menu Handset main menu Telephone base main menu Introducing Bluetooth Bluetooth Glossary of terms Important Information Bluetooth at a glance Device connected to base, and 1 and/or 2 displays Bluetooth setupSetup cell To pair and connect a cell phone To pair and connect a headset Setup headset Rename a paired device Paired devices View information of a paired device Remove a paired device Active devices Review the active devices listConnect/disconnect an active device To add an active device Replace an active deviceAdd an active device To replace an active device Remove an active device View information of an active deviceChange PIN To select a language Handset settingsSettings LCD language Clear voicemail To manually turn off these indicators To change the setting Auto keylockKey tone Set date/time 800 Home area code Ringer volume To adjust the handset ringer volumeRingers To select a ringer tone Ringer tone Telephone base settings LCD Language Turn off indicator? 800 Ringer Volume Ringer tone Select Home Answer ON/OFF Answering system settingsAnswering system setup Using the handset To change the setting Using the telephone base Using a handsetCall screening Play your announcement Announcement Record your own announcement Tone. Press 5 when you are done. After the tone Delete your announcement Number of rings Press the Menu softkey when the handset is not in use Remote access code Message alert tone Make, answer or end a home call Telephone operation Call waiting on the home line Using a Bluetooth headset Make, answer or end a cell call To end the cell call Call waiting on the cell lineAnswer a cell call while on a home call To answer the incoming cell call Conference home and cell calls Answer a home call while on a cell call Mute Volume controlHandset speakerphone Silence the ringer Infrared sensor HoldHandset locator To access a number in the call log while on a Home call To access the last number redial while on a home callChain dialing Save a redial entry to the directory Redial listReview the redial list Dial a redial entry Delete a redial entry Intercom Answer an incoming call during an intercom call To silence an intercom callTo end an intercom call Transfer a call Share an outside call Create a new directory entry Directory Using the telephone base Character chart To start an alphabetical search To review the directory Using a handsetReview the directory Alphabetical search Press /HOME or /CELL To dial a directory entry Using a handsetDial a directory entry Edit a directory entry To delete an entry Delete a directory entry Information about caller ID with call waiting About caller ID Caller ID history Missed calls indicator Review the call log Memory match Dial a call log entry Make a call log entry ready to dial Save a call log entry to the directory To delete a single entry To delete all entries Using a handsetDelete from the call log Call log display screen messages New message indication Answering system operationAnswering system and voicemail Message capacity Message playback To play messages with the telephone baseTo play messages with a handset Delete all old messages Record and play memos To record a memo Using the telephone base Command Remote access Screen display messages Appendix Keypad is locked Telephone base lights Handset and telephone base indicators Handset lights Handset icons Bluetooth disconnected devices indicates that there Telephone base icons Bluetooth wireless headset on steadily when a Operation Operating time Battery Expand your telephone system Add and register a handset optionalTo register a handset To deregister all handsets Replace a handset Cannot pair my headset to the telephone base TroubleshootingCannot use the keypad Cannot pair my cell phone to the telephone base My cell phone disconnects with the telephone base Cannot put my headset in discoverable modeCannot connect my headset with the telephone base Cannot find VTech LS6245 on my cell phone My telephone does not work at all Bluetooth system busy appears on the displayLow battery shows on screen PIN on the telephone base does not work There is no dial tone Charge light is off Cannot dial out Telephone does not ring when there is an incoming call My handset beeps and is not performing normally Registration failed appears on the handset Hear other calls when using the telephoneMy caller ID features are not working properly Hear noise on the cordless handset and the keys do not work Caller ID entries do not match the numbers I need to dial Searching for Base shows in the handset screenCannot retrieve my voicemail messages Outgoing announcement is not clear Messages on the answering system are very difficult to hearAnswering system does not record messages Answering system does not respond to remote commands Messages on the answering system are incompleteCommon cure for electronic equipment Important safety instructions Operating range Maintenance Rbrc seal About cordless telephones What does this limited warranty cover? Warranty Other limitations FCC Part FCC, Acta and IC regulations Industry Canada Technical specifications Index Symbol Index 91-002418-030-100