LEVELING

The manual gas valve, located behind the small door in the lower front panel, should remain off until all electrical and gas connections are made and the ovens are ready to be used.

LEVELING

Ensure that the oven racks are level in the final installed position. If the oven is installed on legs, turn the adjustable feet in or out to level the oven front-to-back and side-to-side.

ELECTRICAL CONNECTIONS

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.

WARNING: APPLIANCES EQUIPPED WITH FLEXIBLE ELECTRICAL POWER SUPPLY CORD ARE PROVIDED WITH A THREE-PRONG GROUNDING PLUG. IT IS IMPERATIVE THAT THIS PLUG BE CONNECTED INTO A PROPERLY GROUNDED THREE-PRONG RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM THIS PLUG.

The SG series ovens are equipped with a 120 volt / 60 Hz. / 1 phase cord and plug.

Refer to the Installation Codes and Standards section of this manual.

A schematic decal is located on the inside of the right side panel.

GAS AND ELECTRICAL DATA

 

 

GAS DATA

 

 

 

 

ELECTRICAL

 

 

 

 

 

 

 

 

 

 

 

 

DATA

 

 

 

 

 

 

 

 

 

 

MODEL

 

 

 

 

 

 

 

 

 

 

INPUT BUT/HR

MANIFOLD PRESSURE

AMP LINE

 

 

 

 

 

 

 

 

 

 

 

 

Natural

Propane

Natural

 

 

Propane

120 Volts

 

 

 

 

 

 

 

 

 

 

 

SG4D/C

 

 

 

 

 

 

 

 

 

 

60,000

60,000

3.5" (03.875"

 

kPa)

10"

 

(2.1490"

kPa)

9 Amps

SG6D/C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SG44D/C

 

 

 

 

 

 

 

 

 

 

120,000

120,000

3.5" (03.875"

 

kPa)

10"

 

(2.1490"

kPa)

18 Amps

SG66D/C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

— 9 —

Page 9
Image 9
Vulcan-Hart SG6D ML-114877, SG4D ML-114875, SG6C ML-114878 Leveling, Electrical Connections, Gas And Electrical Data