1. | Front | 10 hrs. |
2. | Mid | 10 hrs. |
3. | Carrier Bearing Block | 40 hrs. |
4. | Telescoping Shaft | 10 hrs. |
5. | Rear | 10 hrs. |
6. | Rotating Drive Shield | 10 hrs. |
7. | Side Drive Yoke (2 Places) | 40 hrs. |
8. | Gearbox (Check Oil Level, |
|
| Lower Hole on Center Gearbox |
|
| Side Hole on Spindle Gearboxs) | Daily |
9. | Tailwheel Spindle | 20 hrs. |
10. | Caster Wheel Swivel | 40 hrs. |
Figure 12. Jackstand Placement and Lubrication Points
SERVICING BLADES
Removing Blades (Figure 13)
NOTICE
■If blade pin (12) is seized in crossbar and extreme force will be needed to remove it, support crossbar from below to prevent gearbox damage.
1.Disconnect driveline from tractor PTO.
2.Open blade access cover and align crossbar (8) with blade access hole in the cutter frame. Remove cap screw (35), blade pin lock clip (15), keyhole plate (14), and shims (13 & 16). Carefully drive blade pin (12) out of crossbar.
3.Rotate crossbar (8) and repeat for opposite blade.
8.Crossbar
9.Blade
12.Blade pin
13.Shim
14.Keyhole plate
15.Blade pin lock clip
16.Shim
35. Cap screw
Figure 13. Blade Assembly
Installing Blades
CAUTION
Your dealer can supply genuine replacement blades. Substitute blades may not meet original equipment specifications and may be dangerous.
NOTICE
■Crossbar rotation has counterclockwise rota- tion on left gearbox and clockwise rotation on the right gearbox when looking down on cutter. Be sure to install blade cutting edge to lead in correct rotation.
22 Owner Service
(Rev. 10/5/2007) MAN0390 (Rev. 4/6/2007)
