CROSSBAR INSTALLATION
1.Using emery cloth (220 or finer), remove surface rust, and foreign material from hub, splined gearbox vertical shaft, and crossbar. See Figure 24.
Figure 24. Example of Crossbar and Gearbox Shaft
2.Install crossbar (8), Figure 22, on splined shaft. Install castle nut (37) and cotter pin (38). Torque nut to 450 lbs-ft.
3.Install blades, reinstall them using existing hardware. Torque cap screws to 85 lbs-ft.
CROSSBAR TIMING
Crossbar must be
1.To
2.The right crossbar will be at right angles to the front of the cutter.
3.Measure from the front of the cutter to the blade pin on each side crossbar.
4.Hold crossbars in position while connecting the side drivelines.
Figure 25. Crossbar Timing - Bottom View
34 Dealer Service | MAN0390 (Rev. 4/6/2007) |
|
|
