INSTALL TONGUE DS96 & DS120
CUTTERS
Refer to Figure 36.
1.Place tongue (1) between inner mast plates.
NOTE: DS96 only has one set of mast plates. Fig- ure 36 shows the DS120 cutter frame.
2.Place washer (46) and sleeve (16) on cap screw (44).
3.Place washer (47) between mast plates and tongue, insert cap screw (44) with washer (46) and sleeve (16) through mast plate and tongue. NOTE: Washers (47) are only required on DS120 cutters.
4.Secure with second washer (46) and lock nut (45).
5.Attach front half of attitude rod to lug on tongue using clevis pin (17) and cotter pin (48).
6.Raise front of cutter and install parking jack (6) to support tongue.
7.Attach safety tow chain (5) to tongue using cap screw (44), washer (47), and lock nut (45). Be sure chain links do not interfere with tractor drawbar.
INSTALL 3-JOINT DRIVELINE
Install Driveline
Refer to Figure 36.
1.Coat input shaft of gearbox shaft with light coating of grease.
2.Attach slip clutch on driveline (9) to input shaft of gearbox. Tighten cap screws (33) and lock nut (34).
3.Attach rear tether chain on driveline to clip on plastic gearbox shield.
Install H-Frame
1.Place
2.Secure
Attach Driveline to H-frame
NOTE: Select holes in
Place driveline bearing carrier between
Install Front Drive
1.Slide rear yoke of front driveline (8) over shaft of driveline (9) and align with notch on shaft.
2.Secure drives together using cap screw (39) and lock nut (38).
3.Attach tether chain on front half of driveline (8) to
Install Drive Shield & Hose Holder
1.Attach drive shield (13) to driveline carrier bearing using two cap screws (35) and lock washers (36).
2.Attach hydraulic hose holder (15) to the top hole in
Install SMV Bracket
1.Attach SMV bracket (19) to the top of center gearbox using two cap screws (32).
2.Attach SMV emblem (20) to SMV bracket using two round head cap screws (30) and hex nuts (31).
MAN0390 (Rev. 4/6/2007) | Assembly 41 |
|
|
