Xerox 5500 Maintenance Safety, Operational Safety, Overhead Clearance, Total Height Requirements

Maintenance Safety

■Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your printer.

■Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance and could create a hazardous condition.

■Do not burn any consumables or routine maintenance items. For information on Xerox supplies recycling programs, go to www.xerox.com/gwa.

Operational Safety

Your printer and supplies were designed and tested to meet strict safety requirements. These include safety agency examination, approval, and compliance with established environmental standards.

Your attention to the following safety guidelines helps to ensure the continued, safe operation of your printer.

Printer Location

Place the printer in a dust-free area within a temperature range of 41° F to 90° F (5° C to 32° C) and a relative humidity range of 15 percent to 85 percent.

Printer Clearance

Place the printer in an area where there is adequate space for ventilation, operation, and servicing. The recommended minimal spacing is:

Overhead Clearance:

■30 cm (12 in.) above the printer without the finisher/stacker

■47 cm (18.5 in.) above the printer with the finisher/stacker

Total Height Requirements:

■Printer: 74 cm (29 in.)

■Add 29 cm (11.5 in.) for the 1000-sheet feeder

Other Clearances:

■20 cm (8 in.) behind the printer

■46 cm (18 in.) in front of the printer

■50 cm (20 in.) on the left side of the printer

■65 cm (26 in.) on the left side of the printer with 2000-sheet feeder

■20 cm (8 in.) on the right side of the printer

■99 cm (39 in.) on the right side of the printer with the finisher/stacker

Phaser® 5500 Laser Printer

A-3