Belt

MEDIA

Knob

841

Plain

paper

Tracing

paper

Film

9.Insert the lead edge of the media between the upper and lower feed rollers.

10.Rotate the green knob in order to feed an inch (25 mm) of media between the feed rollers.

11.Set the switches for the series and type of media you have loaded, from rear to front:

Arch. (12”, 18”, 24”, 30”, 36”, rolls) or Ansi. (11”, 17”, 22”, 34" rolls) (Rear)

Plain Media

Vellum

Film

(Front)

NOTE:

12.Ensure that the rubber-tracking belt is underneath the plastic roller on the right side of the media spindle. If the belt is not correctly positioned, the printer will indicate an out-of-media condition.

13.Push the drawer in until it is closed and latched.

14.If the leading edge is not sufficiently square, perform the automatic Initial Cut by pressing the [Select] key to select the appropriate drawer, and then pressing [Cut] key. Approximately 9.5” (240mm) media will be cut and fed from the printer.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

Xerox 721P manual Belt

Models: 721P

Belt