Xerox 721P manual Roll 3 only

MEDIA

10.Insert the lead edge of the media between the upper and lower feed rollers.

11.Rotate the lower roller by hand in order to feed an inch (25 mm) of media between the rollers.

Roll 3 only:

12.Rotate the lower feed roller until the lead edge is visible in the center of the viewing hole.

841

Plain

paper

Tracing

paper

Film

Belt

13.Set the switches for the series and type of media you have loaded, from rear to front:

￿Arch. (12”, 18”, 24”, 30”, 36”, rolls) or Ansi. (11”, 17”, 22”, 34" rolls)….(Rear)

￿Plain Media

￿Vellum

￿ Film (Front)

NOTE:

14.Ensure that the rubber-tracking belt is underneath the plastic roller on the right side of the media spindle. If the belt is not correctly positioned, the printer will indicate an out-of-media condition.

15.Push in the drawer until it is closed and latched.

16.If the leading edge is not sufficiently square, perform the automatic initial cut by pressing the [Select] key to select the appropriate drawer, and then pressing [Cut] key. Approximately 9.5” (240mm) media will be cut and fed from the printer.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL 19