Xerox 721P manual User Mode 3 Low Power Saver Mode U3

USER MODES

User Mode 3 (Low Power Saver Mode) “U3”

Menu Enter Online

Press [Menu] 3 times

Menu Enter Online

Menu Enter Online

If the Low Power Saver Mode is enabled, the printer reduces

power to the Printer Fuser Assembly from 178￿C to 100￿C after a predetermined period of inactivity. If the printer does not receive a print job or copy job for the time selected in this mode the printer will enter the Low Power Saver Mode to save power consumption.

If a print or copy job is detected by the printer, the printer will then enter the Warm up Mode prior to the start of the job to heat the Fuser Assembly to 178￿C.

The green LED Light inside of the Menu Button flashes when the printer is in a power saver mode.

1. To enter User Mode 3:

Press the [Menu] Key 3 times when the printer is in the Standby (idle) Mode.

The [Menu] Key lights green and the Status Display indicates “U3" flashing on the left side of the display. The right side of the display shows the current setting (in minutes).

2. Press [Enter]

The status (on or off) is displayed. If the status is off, Low Power Saver is disabled.

To change the status, press [Enter] and then the [ --> ] Key or the [ <-- ] Key.

3.Press [Enter] again for access to the time interval. The current setting (in minutes) is displayed.

The selectable ranges are 10, 15, 20, 30, 40, 50, 60, 90, 120, 180 and 240 minutes. (Factory default is On and set to 15 minutes)

To change the time, press the [ --> ] Key to increase) and the [ <-- ] Key to decrease, then press [Enter] to save the data.

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL 53