USER MODES
User Mode 4 (High Power Saver Mode) “U4”
Menu | Enter | Online |
Press [Menu] 4 times
Menu | Enter | Online |
Menu | Enter | Online |
When the High Power Saver Mode is enabled, the printer switches off power to the Printer Fuser Assembly after a predetermined time of inactivity. If the printer does not receive a print job or a copy job for the time selected in this mode, the printer will enter the High Power Saver Mode to save power consumption.
The High Power Saver Mode saves more power than the Low Power Saver Mode and the recovery time is longer.
If a print or copy job is detected by the printer, the printer will then enter the Warm up Mode prior to the start of the job to heat the Fuser Assembly to 178C.
The green LED Light inside of the Menu Button flashes when the printer is in a power saver mode.
1. To enter User Mode 4:
Press the [Menu] Key 4 times when the printer is in the Standby (idle) Mode.
The [Menu] Key lights green and the Status Display indicates “U4.” Flashing on the left side of the display. The time interval is shown on the right side of the display.
NOTE: Factory default is On and set to 90 minutes.
2. Press [Enter]
The status (on or off) is displayed. If the status is off, High Power Saver is disabled.
To change the status, press [Enter] and then the [
Press [Enter] again to gain access to the time interval.
To change the time, press [
The display value is “minute”, and the selectable ranges are 10, 15, 20, 30, 40, 50, 60, 90, 120, 180 and 240.
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL | 55 |
