PROBLEM SOLVING
Slit |
Cutter |
7.Trim the lead edge of the roll square to remove any torn or wrinkled media by using the “Slit” if necessary.
8.Insert the lead edge of the media between the upper and lower feed rollers and feed an inch of media between the feed rollers.
9.Roll 3 only: Rotate the lower feed roller by hand until the lead edge is visible in the center of the viewing hole.
10.Push in the drawer until it is closed and latched.
11.If the leading edge is not sufficiently square, perform the automatic Initial Cut by pressing the [Select] key to select the appropriate drawer, and then pressing [Cut] key. Approximately 9.5” (240mm) media will be cut and fed from the printer.
42 | XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL |
