MEDIA
Using Manual Bypass Feed
When the desired media is not loaded in the printer, you can bypass the media drawers and manually load cut sheet media into the printer.
Paper Guide |
To manually feed cut sheets into the printer:
1. Select the appropriate cut sheet for the print job.
NOTE:
The printer will accept any media type, regardless of the media type specified. Ensure that the media type is correct or the toner image may rub off of the print as the printer uses media type to determine fusing temperature.
2.Adjust the media guides to the correct size.
3.Feed the cut sheet media squarely into the printer, curl side down and between the guides. For media 24” or wider, the printer will
841mm or wider (greater than 24”): 1 sheet only
279mm (11”) to 609mm (24”) width: up to 50 sheets (457mm - 18 inch length maximum) fed long edge
NOTE: Install the wire form holder tray for paper larger than 18” (447mm).
4.From the client workstation or the scanner, specify Manual Feed as the media source.
5.Submit the print job or scan the document.
24 | XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL |
