Xerox C55/C55mp manual Density and Color Balance Adjustment Procedure, Printing a Test

P R I N T E R M A I N T E N A N C E 7–3

Density and Color Balance Adjustment Procedure

You may notice, over the course of using the printer, that colors may change. For example, reds may begin to take on a purple cast, or blues may take on a green cast. This happens during the normal use of a color printer and can be easily remedied by using the Density/Color Balance Adjustment procedure described below. This procedure, which should be done monthly, will help correct any color shifts.

This Control Panel procedure involves printing a test page and adjusting the densities and colors based on the appearance of the Test Page. You may need to repeat this procedure and test your adjustments until you achieve the desired effect.

NOTE: If, during the adjustment process, you decide to return to your starting point; you can do so by pressing the Enter button when <CANCEL CHANGES> is displayed.

Printing a Test Page

1.Press the On Line button to take the printer off line.

2.Press the Menu button.

3.Press the Next button to scroll through the Top Menu selections.

4.Press Enter when the Top Menu <SETUP MENU> is displayed.

5.Press the Next button to scroll through the sub-menu selections.

6.Press Enter when <COLOR ADJUST> is displayed. The Printer may go through a Print Quality adjustment and the Test Page (See Figure 7–1) will print.