CLP-370: Keyboard Stand Assembly

1. Attach C to D and E.

D

 

C

 

E

 

1-2

ENGLISH

1-1

1-1Untie and straighten out the bundled pedal cord.

 

 

Do not discard the vinyl tie. You will need it later

 

in step 5.

 

1-2Attach D and E to C by tightening four long

 

screws (6 x 25 mm).

2. Attach B.

Depending on the model of Clavinova you pur- chased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color most similar to D and E faces you (as you would play the instrument)

2-1Align the screw holes on the upper side of B with the bracket holes on D and E, then attach the upper corners of B to D and E by finger-tightening two thin screws (4 x 12 mm).

2-2Secure the bottom end of B using four tapping screws (4 x 20 mm).

2-3Securely tighten the screws on the top of B that were attached in Step 2-1.

2-1

2-3

E

B

D

2-2

3. Mount A.

Make sure that you mount the main unit by holding the front bottom in areas that are at least 15 cm towards the center from either end and by the handles on the rear panel.

A

Align the screw

15 cm or further in

holes.

CAUTION

Be extra careful not to drop or let your fingers be pinched by the main unit.

CAUTION

Do not hold the main unit in any position other than the position specified above.

4. Secure A.

4-1Adjust the position of A so that the left and right ends of A will project beyond D and E equally (as seen from the front).

4-2Secure A by tightening six short screws (6 x 16 mm) from the front.

4-1

A

Projection of A

A

4-2

82CLP-370/340/330, CLP-S308/S306 Owner’s Manual