5. Connect the pedal cord.

5-1Pass the pedal cord from the rear and insert the plug into the pedal connector.

5-2Attach the cord holders to the rear panel as shown, then clip the cord into the holders.

5-3Use a vinyl tie to take up any slack in the pedal cord.

5-1

PED

 

AL

 

 

127

 

6-2

220

 

110

 

240

6-1

5-2

5-3

6. Connect the power cord.

6-1Set the voltage selector (for models that feature a voltage selector).

Voltage Selector

Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a “minus” screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC IN and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area.

6-2Pass the power cord from the rear and insert the plug into the power connector.

CLP-370: Keyboard Stand Assembly

7. Set the adjuster.

Rotate the adjuster until the pedal box comes in firm contact with the floor surface.

8. Attach the headphone hanger.

Use the included two screws (4 x 10 mm) to attach the hanger as shown in the illustration.

ENGLISH

After completing the assembly, please check the fol- lowing.

•Are there any parts left over?

Review the assembly procedure and correct any errors.

•Is the instrument clear of doors and other movable fixtures?

Move the instrument to an appropriate location.

•Does the instrument make a rattling noise when you shake it?

Tighten all screws.

•Does the pedal box rattle or give way when you step on the pedals?

Turn the adjuster so that it is set firmly against the floor.

•Are the pedal and power cords inserted securely into the sockets?

Check the connection.

•If the unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws.

CAUTION

When moving the instrument after assembly, always hold instrument by the lower surface in the front of the main unit and by the handles in the rear of the main unit.

CAUTION

Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury.

Top portion

Key cover

Hold here.

Do not hold

 

here.

CLP-370/340/330, CLP-S308/S306 Owner’s Manual

83