5. Connect the speaker cord.

5-1Remove the twist tie attaching the speaker cord.

5-2Insert the speaker cord plug into the connector so that the protruding tab on the plug faces toward right when viewed from the rear.

5-2

6. Connect the pedal cord.

6-1Insert the pedal cord plug into the [PEDAL] con- nector.

6-2Attach the cord holders to the instrument as shown, then clip the cord into the holders. At this time, be careful not to allow too much slack in the pedal cord between the plug and cord holder.

6-1

6-2

E

7. Attach C.

7-1Place on D, the stopper-wood in the bottom corners of C, then attach the top of C.

7-2Secure upper right and left of C using two thin screws (4 x 14 mm).

7-3Secure upper center and bottom of C using five tapping screws (4 x 20 mm).

7-2

7-1

D

C

C

 

7-3

 

CLP-S308/S306: Keyboard Stand Assembly

8. Connect the power cord.

8-1For models that feature a voltage selector: Set the

voltage selector to an appropriate voltage.

Voltage Selector

 

ENGLISH

selector dial so that the correct voltage for your region

 

Before connecting the AC power cord, check the setting

 

 

of the voltage selector which is provided in some

 

 

areas. To set the selector for 110V, 127V, 220V or 240V

 

 

main voltages, use a “minus” screwdriver to rotate the

 

 

appears next to the pointer on the panel. The voltage

 

 

selector is set at 240V when the unit is initially

 

 

 

shipped. After the proper voltage has been selected,

 

 

connect the AC power cord to the AC IN and an AC

 

 

wall outlet. A plug adaptor may be also provided in

 

 

some areas to match the pin configuration of the AC

 

 

wall outlets in your area.

 

 

 

 

 

WARNING

An improper voltage setting can cause serious damage to the Clavinova or result in improper operation.

8-2Insert the AC power cord plug into the [AC IN] connector.

9. Set the adjuster to secure the pedals.

Rotate the adjuster until the pedal box comes in firm contact with the floor surface.

10.Attach the headphone hanger.

Use the included two screws (4 x 10 mm) to attach the hanger as shown in the illustration.

CLP-370/340/330, CLP-S308/S306 Owner’s Manual

89