1. Attach C to D and E.

D

CLP-340/330: Keyboard Stand Assembly

3. Mount A.

Be sure to place your hands at least 15 cm from either end of the main unit when positioning it.

1-1

C E

A

15 cm or

1-2

1-1Untie and straighten out the bundled pedal cord. Do not discard the vinyl tie. You will need it later in step 5.

1-2Attach D and E to C by tightening four long screws (6 x 25 mm).

2. Attach B.

Depending on the model of Clavinova you pur- chased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color most similar to D and E faces you (as you would play the instrument).

2-1Place the lower side of B on each foot of D and E, then align the screw holes on the upper side of B with the bracket holes on D and E.

2-2Attach the top corners of B to D and E by finger- tightening two thin screws (4 x 12 mm).

2-3While pushing the lower part of D and E from outside, secure the bottom end of B using four tapping screws (4 x 20 mm).

2-4Securely tighten the screws on the top of B that were attached in Step 2-2.

 

2-2

2-1

2-4

 

 

E

Place the bot-

B

D

tom end of the

 

rear panel on each foot.

2-3

further in

15 cm or further in

ENGLISH

CAUTION

Be extra careful not to drop or let your fingers be pinched by the main unit.

CAUTION

Do not hold the main unit in any position other than the position specified above.

4. Secure A.

4-1Adjust the position of A so that the left and right ends of A will project beyond D and E equally (as seen from the front).

4-2Secure A by tightening the short screws (6 x 16 mm) from the front.

4-1

A

Projection

of A

4-2

Insert the screw in the front of

these two holes.

CLP-370/340/330, CLP-S308/S306 Owner’s Manual

85