Yamaha manual 88

CLP-S308/S306: Keyboard Stand Assembly

1. Attach D to E and F.

		1-1
	F	1-3
		E
		D
ENGLISH	1-2
	1-1Attach D to E and F by using four long screws
	(6 x 20 mm).

1-2Secure D from the rear using two long screws (6 x 20 mm).

1-3Remove the twist tie from the folded pedal cord. Do not remove the twist tie that is located next to the hole.

2. Attach B.

2-1Insert B between E and F as shown in the illustration. 2-2Align and attach B to the front side of D, E and F.

2-1

2-2

F

B

E

D

2-3Temporarily secure B by finger-tighening four long screws (6 x 20mm).

*Insert four screws into the larger holes (all four holes) on the brackets.

2-4Secure B using a thin screw (4 x 14 mm).

*Insert the screw into the smaller hole on the bracket.

2-4

2-3

3. Mount A.

3-1Place your hands at least 15 cm from either end of A to mount it.

3-2Position A so that the stopper-wood on the rear side of the bottom of A will be located behind the front panel, then slide A slowly toward the rear.

	A
15cm	3-1
or
further in
3-2	15cm
	or
	further in

CAUTION

Be extra careful not to drop or let your fingers be pinched by the main unit.

CAUTION

Do not hold the keyboard in any position other than the position shown in the illustration.

4. Secure A.

4-1Secure A from the rear using two short screws (6 x 16 mm).

4-2Secure A from the rear using two thin screws (4 x 14 mm).

4-3Secure A from the front using four short screws (6 x 16mm).

4-2

A

4-1 4-3

4-4Firmly tighten the screws you temporarily fastened on B in steps 2-3 above.

4-4

88CLP-370/340/330, CLP-S308/S306 Owner’s Manual