SCSI Connection Set Up

Setting the Jumper Switches

8Before fitting the CRW2200S into the computer, you need to set up the drive using the jumper switches located at the rear of the unit. You’ll need to set the following:

SCSI ID number

Parity check

Termination

Block size

To set each jumper switch, you have to bridge the two pins in the respective column of the grid with a plastic shunt. Shunts are already attached to the jumper switches in their default configurations.

Jumper switches

1 2 4

ID SELECT PARITY. TERMINATOR BLOCK SIZE

Rear Panel

Note

The plastic shunts actually contain metal for bridging the two pins of a jumper switch, creating an electrical connection between them when attached. When removed, the jumper switch is set to “OFF.” Store unused shunts in a safe place where they will not be lost.

Use a pair of long-nosed pliers to attach or detach the plastic shunts accordingly. Make sure that the computer is turned off beforehand.

20

Page 28
Image 28
Yamaha CRW2200S manual Setting the Jumper Switches, Jumper switches, Rear Panel