Reference SectionReference Section
Playback Control
119

● Selecting a Song

The QY100 can retain up to 20 different songs in memory
at the same time: song numbers 01 through 20 (three demo
songs are recorded as song numbers 21 through 23). To select a
song for playback use the cursor buttons to move the cursor to
the song number location (the song number will be highlighted),
and then use the [-1] and [+1] buttons or the SHIFT-Number entry
method desribed below to select the desired song number. If the
song has been given a name (this is done via the Song Name job
described on page 180), the song name will appear to the right of
the song number.
The SHIFT-Number Entry Method
Numeric values can be directly entered by using the black
micro-keyboard keys (numbered 1 through 0) while holding
the [SHIFT] button. To enter the number “16”, for example,
press the “1” and then the “6” keys (“F#/Gb” and “7(#9)/
7(b9)” on the micro-keyboard) while holding the [SHIFT]
button. The entered number — “16” — will flash on the
display. Press the [ENTER] button to actually enter the
number.
Negative values can be entered where applicable by first
pressing the “E” (“-”) key on the micro-keyboard while
holding the [SHIFT] button, and then entering the value as
described above.

● Playing the Selected Song

Playback of the selected song is started by pressing the [>]
(“PLAY”) sequencer button. The green LED will flash at the play-
back tempo. The song will play through to the end and then stop
automatically. Song playback can also be stopped at any time by
pressing the [■] sequencer button.
■
NOTE
• When a song is selected, its voice and effect settings will be recalled.
Therefore, you should wait for about 1 second until pressing the [
>
] but-
ton after selecting a song.