The Pattern Jobs
187
Increases or decreases the velocity values of all notes in the speci-
fied track and range of measures.
The “TR” parameter selects the track to be affected by the Modify
Velocity job: D1, D2, PC, BA, C1, C2, C3, C4.
The “M” parameters above the graphic bar are used to specify the
first measure:beat and last measure:beat of the range to be modified.
The “SetAll” parameter makes it possible to set all notes in the
specified range to a single velocity value from “1” to “127”. “Set All” can
also be turned “Off” when the “Rate” and “Offset” parameters, below,
are to be used for velocity modification.
The “Rate” parameter allows you to change the Velocity value of
each note without affecting the velocity ratios between notes (proportional
change). A setting of
“100%” maintains the
absolute velocity differ-
ences between notes,
while lower (higher) val-
ues will decrease
(increase) the velocity val-
ues to the corresponding
percentage, resulting in a
narrower (wider) dynamic
range. The range is from
“0%” to “200%”.
02 : Modify Velocity
First measure Last measure
First beat Last beat
96 64 32 127 96
48 32 16 63 48
127 96 48 127 127
Original
velocities
Rate = 50%
Rate = 150%