Configuration
Configuration and Calibration Sequence
Display Shows | Action/Explanation |
|
|
PROTOCOL | Press SELECT to make change. |
| Setting Protocol: Press PLUS (+) or MINUS |
| other choices. |
| Default: None |
| Selections: None, Zebra, ACK_NACK |
| Press SELECT to accept the change. |
| Protocol is a type of error checking system. Depending on |
| the selection, an indicator may be sent from the printer to the |
| host computer signifying that data has been received. Select |
| the protocol that is requested by the host computer. Further |
| details on protocol can be found in the ZPL II Programming |
| Guide Volume I. |
| Zebra is the same as ACK_NACK except that with Zebra the |
| response messages are sequenced. |
| If Zebra is selected, printer must use DTR/DSR host |
| handshake protocol. |
NETWORK ID | Press SELECT to make change. |
| Setting Network ID: Press MINUS |
| digit position, press PLUS (+) to increase the value of the |
| digit. |
| Default: 000 |
| Range: 000 to 999 |
| Press SELECT to accept the change. |
| Network ID is used to assign a unique number to a printer |
| used in an |
| computer the means to address a specific printer. If the |
| printer is used in a network, you must select a network ID |
| number. This does not affect TCP/IP or IPX networks. |
|
|
Z4Mplus and Z6Mplus User Guide | 73 |