Printer Setup

Basic Configuration

15.Press PLUS (+) to move to the next option. PRINT MODE displays.

When the wrong Print Mode is selected, the top of the label is not found by the printer. Some examples of common problems are gaps between noncontinuous labels not lining up on the tear bar, or continuous media not being cut at the right interval.

If the labels line up correctly on the tear bar, press PLUS (+) to go to the next step, Media Type.

If the labels are not lined up correctly, review the media and the printer options, then adjust accordingly, continue with Step 16.

16.Press SELECT.

17.Press PLUS (+) or MINUS (–) to scroll through the setting options. Stop at the setting that matches your printer options (Tear-Off, Peel-Off, Cutter, or Rewind)

18.Press SELECT to accept the change.

19.Press PLUS (+) to move to the next option, MEDIA TYPE displays.

Types of Media on page 10 showed examples of non-continuous and continuous media.

If your media matches the Media Type, press PLUS (+) to go to the next step, Sensor Type.

If your label media does not match the Media Type, follow the steps below.

20.Press SELECT.

21.Press PLUS (+) or MINUS (–) to scroll through the setting options. Stop at the setting that matches your printer options (Continuous or Noncontinuous).

22.Press SELECT to accept the change.

23.Press PLUS (+) to move to the next option. SENSOR TYPE displays.

Web sensor is used with most labels, unless the label liner has black marks on the back.

If your liner does not have black marks, press PLUS (+) to go to the next step, Sensor Select.

24

Z4Mplus and Z6Mplus User Guide