Zebra Technologies Z4Mplus PLUS, PLUS, MINUS, MINUS, SELECT, SELECT, SELECT, SELECT, SELECT, Default:, IP Address:, Selections:, Default Gateway:

Configuration

Configuration and Calibration Sequence

Display Shows	Action/Explanation
IP ADDRESS*	Press SELECT to make change.
	IP Address: Press MINUS (–) to move to the next digit
	position, press PLUS (+) to increase the value of the digit.
	This parameter allows you to select the IP address if
	permanent was chosen in IP RESOLUTION. (If dynamic
	was chosen, the user cannot select the address.) For more
	information, see ZebraNet Networking: PrintServer II
	Installation and Users Guide.
SUBNET MASK*	Press SELECT to make change.
	Subnet Mask: Press PLUS (+) or MINUS (–) to display
	other choices.
	Default: Permanent (user must set)
	Selections: Dynamic (user may set, but server can assign),
	permanent
	Press SELECT to accept the change.
	This parameter selects the part of the IP address that is
	considered to be part of the local network. It can be reached
	without going through the default gateway.
DEFAULT GATEWAY*	Press SELECT to make change.
	Default Gateway: Press MINUS (–) to move to the next
	digit position, press PLUS (+) to increase the value of the
	digit.
	Press SELECT to accept the change.
	This parameter allows you to select the IP address that the
	network traffic is routed through if the destination address is
	not part of the local network.

* External ZebraNet PrintServer II or Cobra Internal option required

82 Z4Mplus and Z6Mplus User Guide