Zebra Technologies Z4Mplus PLUS, PLUS, PLUS, PLUS, MINUS, MINUS, MINUS, SELECT, SELECT, SELECT, SELECT, SELECT, SELECT, List Fonts:, Default; Range:, List Bar Codes:

Configuration

Configuration and Calibration Sequence

Display Shows	Action/Explanation
PRINT WIDTH	Press SELECT to make change.
	Setting Print Width: Press PLUS (+) to increase the value,
	press MINUS (–) to decrease the value. To change the unit
	of measurement, press MINUS (–) until the unit of
	measurement is active, then press PLUS (+) to toggle to a
	different unit of measure (inches, mm, or dots).
	Default; Range: The default and range of acceptable values
	may vary depending on what printer you have. See Printing
	Specifications on page 115 for further information about the
	ranges available for your model.
	Press SELECT to accept the change.
	Print width determines the printable area across the width of
	the label.
MAXIMUM LENGTH	Press SELECT to make change.
	Setting Maximum Length: Press PLUS (+) to increase the
	value, press
	MINUS (–) to decrease the value. Default is 39 in. (991
	mm) for non-continuous material.
	Press SELECT to accept the change.
	Always set the value to at least 1 in. (25.4 mm) longer than
	the longest label to be used in the printer.
LIST FONTS	Press SELECT to select.
	List Fonts: Press PLUS (+) to print a label listing all of the
	available fonts.
	This selection is used to print a label that lists all of the fonts
	currently available in the printer, including standard printer
	fonts plus any optional fonts. Fonts may be stored in RAM,
	FLASH memory, font EPROMs, or font cards.
LIST BAR CODES	Press SELECT to select.
	List Bar Codes: Press PLUS (+) to print a label listing all
	of the available bar codes.
	This selection is used to print a label that lists all of the bar
	codes currently available in the printer.

Z4Mplus and Z6Mplus User Guide 65