Zebra Technologies Z4Mplus PLUS, MINUS, MINUS, SELECT, SELECT, Sensor Profile:, Manual Calibration: Press PLUS (+) to start the

Configuration

Configuration and Calibration Sequence

Display Shows Action/Explanation

Media and Ribbon Sensor Calibration

Performing the manual calibration procedure resets the sensitivity of the sensors to detect the media and ribbon you are using more accurately. With the sensors at their new sensitivity, the printer then performs the manual calibration. Changing the type of ribbon and/or media may require resetting the sensitivity of the media and ribbon sensors.

SENSOR PROFILE	Press SELECT to make change.
	Sensor Profile: Press PLUS (+) to print a media sensor
	profile.
	The media sensor profile may be used to troubleshoot
	registration problems that may be caused when the media
	sensor detects preprinted areas on the media or experiences
	difficulty in determining web location. If the sensitivity of
	the media and/or ribbon sensors MUST be adjusted, use the
	manual calibration procedure.
MEDIA AND RIBBON	Press SELECT to display MEDIA AND RIBBON
	CALIBRATE.
	Manual Calibration: Press PLUS (+) to start the
	calibration procedure.
	This procedure is used to reset the sensitivity of the media
	and ribbon sensors. The manual calibration is then
	performed.
LOAD BACKiNG	Open the printhead.
	Remove approximately 8 in. (200 mm) of labels from the
	media roll, enough so that only the liner material is threaded
	between the media sensors when the media is loaded.
	Close the printhead.
	To cancel the operation, press MINUS (–).
REMOVE RiBBON	Open the printhead.
	Remove the ribbon (sliding it as far to the right as possible
	has the same effect as removing it).
	Close the printhead.
	To cancel the operation, press MINUS (–).

Z4Mplus and Z6Mplus User Guide 69