Zebra Technologies Z6M ŸØÏ‹›lÍAÃlÍA›cÍcØÆÏ-l›ÏÆ, Ohdqlqj, Direct Thermal Mode After every roll

/ŸØÏ‹›lÍ￿AÃlÍA›cÍ￿c•ØÆÏ–l›ÏÆ

&OHDQLQJ

Table 2 provides a recommended cleaning schedule. Specific cleaning procedures are provided on the following pages.

Table 2

	Area	Method	Interval
Printhead		Solvent*	Direct Thermal Mode: After every roll of
			media (or 500 feet of fanfold media).
Platen roller		Solvent*
			Thermal Transfer Mode: After every roll of
Media sensors		Air blow
			ribbon or three rolls of media.
Ribbon sensor		Air blow	These intervals are intended as guidelines only.
Media path		Solvent*	You may have to clean more often, depending
			upon your application and media.
Ribbon path		Solvent*
Pinch roller. (Optional value peel-off		Solvent*
option required. See Figure 26.)
	If cutting continuous,	Solvent*	After every roll of media (or more often,
	pressure-sensitive media		depending upon your application and media).
Cutter
	If cutting tag stock or label	Solvent*	After every two or three rolls of media.
Module
	liner material	and air
		blow
Tear-off/peel-off bar		Solvent*	Once a month.
Take label sensor		Air blow	Once every six months.

* Zebra recommends using 90% isopropyl alcohol as the solvent.

CAUTION: Use only the cleaning agents indicated. Zebra Technologies Corporation will not be responsible for damage caused by any other cleaning fluids used on the Z4M or Z6M printer.

Zebra Z4M/Z6M Printers User’s Guide 55