Zebra Technologies Z6M manual OHDQLQJWKH&XWWHU0RGXOH, Technician

&OHDQLQJ￿WKH￿&XWWHU￿0RGXOH

(Cutter option required)

:$51,1*￿￿￿)RU￿SHUVRQQHO￿VDIHW\￿￿$/:$<6￿WXUQ￿RII￿DQG￿XQSOXJ￿

WKH￿SULQWHU￿EHIRUH￿SHUIRUPLQJ￿WKLV￿SURFHGXUH￿

Refer to Figure 27.

To clean adhesive off of the upper and lower cutter blades:

1.Remove the cutter shield by removing the thumbscrew and lock washer.

2.Use a swab moistened with solvent to wipe along the upper cutter blade.

3.To expose the lower cutter blade, turn the cutter motor thumbnut counterclockwise until you see the “V”-shaped lower cutter blade.

4.Clean the lower blade, following the instructions in step 2.

5.Replace the cutter shield.

6.When you have finished cleaning the cutter module, plug in and turn on the printer. The lower cutter blade returns to its correct operating position.

If the cutter continues to perform unsatisfactorily, contact an authorized service

technician.
	Cutter	Upper
	Shield
		Cutter
Thumbscrew		Blade
and
Lock Washer		Lower
		Cutter
		Blade
		Cutter
		Motor
		Thumbnut

Figure 27

64 Zebra Z4M/Z6M Printers User’s Guide