ZyXEL Communications metrogigabit switch manual 110, Vid

Chapter 8 Basic Setting

Table 12 Basic Setting > IP Setup (continued)

LABEL	DESCRIPTION
Default	Specify which traffic flow (In-Bandor Out-of-band) the Switch is to
Management	send packets originating from itself (such as SNMP traps) or packets
	with unknown source.
	Select Out-of-bandto have the Switch send the packets to the out-
	of-band management port. This means that device(s) connected to
	the other port(s) do not receive these packets.
	Select In-Bandto have the Switch send the packets to all ports
	except the out-of-band management port to which connected
	device(s) do not receive these packets.
In-Band Management IP Address
DHCP Client	Select this option if you have a DHCP server that can assign the
	Switch an IP address, subnet mask, a default gateway IP address and
	a domain name server IP address automatically.
Static IP Address	Select this option if you don’t have a DHCP server or if you wish to
	assign static IP address information to the Switch. You need to fill in
	the following fields when you select this option.
IP Address	Enter the IP address of your Switch in dotted decimal notation for
	example 192.168.1.1.
IP Subnet Mask	Enter the IP subnet mask of your Switch in dotted decimal notation
	for example 255.255.255.0.
Default Gateway	Enter the IP address of the default outgoing gateway in dotted
	decimal notation, for example 192.168.1.254.
VID	Enter the VLAN identification number associated with the Switch IP
	address. This is the VLAN ID of the CPU and is used for management
	only. The default is "1". All ports, by default, are fixed members of
	this "management VLAN" in order to manage the device from any
	port. If a port is not a member of this VLAN, then users on that port
	cannot access the device. To access the Switch make sure the port
	that you are connected to is a member of Management VLAN.
Out-of-band Management IP Address
IP Address	Enter the IP address of your Switch in dotted decimal notation for
	example 192.168.0.1.
	If you change this IP address, make sure the computer connected to
	this management port is in the same subnet before accessing the
	Switch.
Subnet Mask	Enter the IP subnet mask of your Switch in dotted decimal notation
	for example 255.255.255.0.
Default Gateway	Enter the IP address of the default outgoing gateway in dotted
	decimal notation, for example 192.168.0.254.
Apply	Click Apply to save your changes to the Switch’s run-time memory.
	The Switch loses these changes if it is turned off or loses power, so
	use the Save link on the top navigation panel to save your changes to
	the non-volatile memory when you are done configuring.
Cancel	Click Cancel to begin configuring the fields again.

110

MGS3700-12C User’s Guide