ZyXEL Communications metrogigabit switch manual Spanning Tree Configuration, 154

Chapter 13 Spanning Tree Protocol

13.3 Spanning Tree Configuration

Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch. Click Configuration in the Advanced Application > Spanning Tree Protocol.

Figure 71 Advanced Application > Spanning Tree Protocol > Configuration

The following table describes the labels in this screen.

Table 27 Advanced Application > Spanning Tree Protocol > Configuration

LABEL	DESCRIPTION
Spanning Tree	You can activate one of the STP modes on the Switch.
Mode	Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or
	Multiple Spanning Tree. See Section 13.1 on page 147 for
	background information on STP.
Apply	Click Apply to save your changes to the Switch’s run-time memory. The
	Switch loses these changes if it is turned off or loses power, so use the
	Save link on the top navigation panel to save your changes to the non-
	volatile memory when you are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.

154

MGS3700-12C User’s Guide