ZyXEL Communications metrogigabit switch manual Viewing and Editing Policy Configuration, 223

	Chapter 21 Policy Rule
Table 57 Advanced Application > Policy Rule (continued)
LABEL	DESCRIPTION
Outgoing	Select Send the packet to the mirror port to send the packet to the
	mirror port.
	Select Send the packet to the egress port to send the packet to the
	egress port.
Metering	Select Enable to activate bandwidth limitation on the traffic flow(s) then
	set the actions to be taken on out-of-profile packets.
Out-of-profile	Select the action(s) to be performed for out-of-profile traffic.
action	Select Drop the packet to discard the out-of-profile traffic.
	Select Change the DSCP value to replace the DSCP field with the value
	specified in the Out of profile DSCP field.
	Select Set Out-Drop Precedence to mark out-of-profile traffic and drop
	it when network is congested.
	Select Do not drop the matching frame previously marked for
	dropping to queue the frames that are marked to be dropped.
Add	Click Add to inset the entry to the summary table below and save your
	changes to the Switch’s run-time memory. The Switch loses these changes
	if it is turned off or loses power, so use the Save link on the top navigation
	panel to save your changes to the non-volatile memory when you are
	done configuring.
Cancel	Click Cancel to reset the fields back to your previous configuration.
Clear	Click Clear to set the above fields back to the factory defaults.

21.3 Viewing and Editing Policy Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Policy screen. To change the settings of a rule, click a number in the Index field.

Figure 104 Advanced Application > Policy Rule: Summary Table

MGS3700-12C User’s Guide

223