ZyXEL Communications metrogigabit switch manual Source, 179

Chapter 16 Mirroring

Figure 82 Advanced Application > Mirroring> RMirror

The following table describes the labels in this screen.

Table 38 Advanced Application > Mirroring> RMirror

LABEL	DESCRIPTION
Active	Enable RMirror
RMirror VLAN ID	Enter a RMirror VLAN ID to create a RMirror VLAN
Apply	Click Apply to save your changes to the Switch's run‐time
	memory. The Switch loses these changes if it is turned off or
	loses power, so use the Save link on the top navigation panel
	to save your changes to the non‐volatile memory when you
	are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.
VLAN	This field displays the VLAN ID
Active	This field displays the RMirror
Delete	To delete a RMirror VLAN(s), select the rule(s) that you want
	to remove in the Delete column, then click the Delete button.
Cancel	Click Cancel to clear the Delete check boxes.

16.2.3 Source

It will mirror port traffic to intermediate switch or destination switch by RMirror VLAN. In different scenario of source switch, the configuration is different.

Click Advanced Application > Mirroring > RMirror > Source on the up right of the navigation panel to display the screen shown. See the Table 39 on page 180 for more information on Source switch.

MGS3700-12C User’s Guide

179